Lynx Rapid Plus Cy5 antibody conjugation kit™ LNK212CY5 bio-rad ,Lynx Rapid Plus Cy5 antibody conjugation kit™-试剂- bio-rad伯乐一级代理 |伯乐Aminex |伯乐电泳槽1658001| 伯乐ddPCR bio-rad授权代理商、biorad伯乐qpcr仪

Lynx Rapid Plus Cy5 antibody conjugation kit™ LNK212CY5 bio-rad ,Lynx Rapid Plus Cy5 antibody conjugation kit™

2024-10-22

Lynx Rapid Plus Cy5 antibody conjugation kit™

货号：LNK212CY5,LNK211CY5

规格：1 Conjugation For 2mg Antibody,3 Conjugations For 200µg Antibody

价格：9282,6307

产品类型：流式抗体

品牌：Bio-Rad

物种：其它

宿主：其它

抗体亚型：其它

荧光染料：其它

产品介绍
Lynx Rapid Plus Cy5 antibody conjugation kitenables the ultra rapid conjugation of a pre-prepared lyophilized mixture containing Cyanine Dye5 (Cy5) label to an antibody or protein. Activation of proprietary reagents within the antibody-label solution results in the coupling of Cy5 to the antibody.The LYNX Rapid Plus kit can be used to label small quantities of antibody/protein at near neutral pH, allowing a high conjugation efficiency with 100% antibody recovery.
产品详情
Reagents in the Kit	Pack Size: 3 Conjugations For 200µg Antibody3 Vials LYNXTMRapid Plus lyophilized Cy5 mix1 Vial LYNXTMRapid Plus Modifier reagent1 Vial LYNXTMRapid Plus Quencher reagentPack Size: 1 Conjugation For 2mg Antibody1 Vial LYNXTMRapid Plus lyophilized Cy5 mix1 Vial LYNXTMRapid Plus Modifier reagent1 Vial LYNXTMRapid Plus Quencher reagent
Preparing The Antibody	Pack Size: 3 Conjugations For 200µg AntibodyThe following buffer solutions are recommended for preparing the antibody:10-50mM amine-free buffer (e.g HEPES, MES, MOPS and phosphate) pH range 6.5-8.5.Do not use buffers containing nucleophilic components e.g primary amines and thiols since they may react with LYNXTMchemicals, and Thiomersal should also be avoided. Azide (0.02-0.1%), BSA (0.1-0.5%), EDTA, Glycerol (up to 50%), and common non-buffering salts and sugars have little or no effect on conjugation efficiency.It is recommended that 100-200ug antibody be used in each labelling reaction. For optimal results the antibody should be at a concentration of 1mg/ml, with a maximum volume of 100ul and a recommended antibody amount of 100ug. A maximum of 200ug of antibody can be used to obtain good quality conjugates as long as the maximum conjugation volume of 100ul is not exceeded. Antibody below 1mg/ml can still be used as long as the maximum volume is not exceeded. Using less than the recommended amount of antibody may result in unbound label, but this will be removed during subsequent application wash steps. Antibody below 0.5mg/ml should be concentrated before use with the kit.Pack Size: 1 Conjugation For 2mg AntibodyThe following buffer solutions are recommended for preparing the antibody:10-50mM amine-free buffer (e.g HEPES, MES, MOPS and phosphate) pH range 6.5-8.5.Do not use buffers containing nucleophilic components e.g primary amines and thiols since they may react with LYNXTMchemicals, and Thiomersal should also be avoided. Azide (0.02-0.1%), BSA (0.1-0.5%), EDTA, Glycerol (up to 50%), and common non-buffering salts and sugars have little or no effect on conjugation efficiency.It is recommended that 1-2mg antibody be used in each labelling reaction. For optimal results the antibody should be at a concentration of 1mg/ml, with a maximum volume of 1ml and a recommended antibody amount of 1mg. A maximum of 2mg of antibody can be used to obtain good quality conjugates as long as the maximum conjugation volume of 1ml is not exceeded. Antibody below 1mg/ml can still be used as long as the maximum volume is not exceeded. Using less than the recommended amount of antibody may result in unbound label, but this will be removed during subsequent application wash steps. Antibody below 0.5mg/ml should be concentrated before use with the kit.
Acknowledgements	This product or portions thereof is manufactured under license from Carnegie Mellon University under U.S. Patent Number 5,268,486 and related patents. Cy and CyDye are trademarks of GE Healthcare Limited.
Regulatory	For research purposes only
Guarantee	12 months from date of despatch
存储条件
This kit contains lyophilized hygroscopic components that are moisture-sensitive. This kit is shipped under ambient conditions with silica packets to avoid exposure to moisture. On receipt, Bio-Rad recommend that the kit is stored at -20℃ and protected from moisture. Storage in frost-free freezers is not recommended.This product should be stored undiluted. Avoid repeated freezing and thawing. Before opening, allow the components to reach room temperature to minimize condensation.
应用
Application Name	Verified	Min Dilution	Max Dilution
Conjugation	√
This product has been reported to work in the following applications. This information is derived from testing within our laboratories, peer-reviewed publications or personal communications from the originators. Please refer to references indicated for further information. For general protocol recommendations, please visit theantibody protocolspage. Instructions For Use 1. To the antibody sample add 1μl of the Modifier reagent for every 10μl of antibody and mix gently.2. Pipette the mixed antibody-modifier sample directly onto the LYNX lyophilized mix and gently pipette up and down twice to resuspend.3. Replace cap onto vial and incubate at room temperature (20-25°C) for 3 hours, or overnight if preferred.4. After incubation, add 1μl of Quencher reagent for every 10μl of antibody used. Leave to stand for 30 minutes before use. 1. To the antibody sample add 1ul of the Modifier reagent for every 10ul of antibody and mix gently.2. Pipette the mixed antibody-modifier sample directly onto the LYNX lyophilized mix and gently pipette up and down twice to resuspend.3. Replace cap onto vial and incubate at room temperature (20-25oC) for 3 hours, or overnight if preferred.4. After incubation, add 1ul of Quencher reagent for every 10ul of antibody used. Leave to stand for 30 minutes before use. 1. To the antibody sample add 1μl of the Modifier reagent for every 10ul of antibody and mix gently.2. Pipette the mixed antibody-modifier sample directly onto the LYNX lyophilized mix and gently pipette up and down twice to resuspend.3. Replace cap onto vial and incubate at room temperature (20-25oC) for 3 hours, or overnight if preferred.4. After incubation, add 1μl of Quencher reagent for every 10μl of antibody used. Leave to stand for 30 minutes before use. 1. To the antibody sample add 1μl of the Modifier reagent for every 10μl of antibody and mix gently.2. Pipette the mixed antibody-modifier sample directly onto the LYNX lyophilized mix and gently pipette up and down twice to resuspend.3. Replace cap onto vial and incubate at room temperature (20-25oC) for 3 hours, or overnight if preferred.4. After incubation, add 1μl of Quencher reagent for every 10μl of antibody used. Leave to stand for 30 minutes before use. 1. To the antibody sample add 1μl of the Modifier reagent for every 10μl of antibody and mix gently.2. Pipette the mixed antibody-modifier sample directly onto the LYNX lyophilized mix and gently pipette up and down twice to resuspend.3. Replace cap onto vial and incubate at room temperature (20-25oC) for 3 hours, or overnight if preferred.4. After incubation, add 1μl of Quencher reagent for every 10μl of antibody used. Leave to stand for 30 minutes before use. 1. To the antibody sample add 1μl of the Modifier reagent for every 10μl of antibody and mix gently.2. Pipette the mixed antibody-modifier sample directly onto the LYNX lyophilized mix and gently pipette up and down twice to resuspend.3. Replace cap onto vial and incubate at room temperature (20-25oC) for 3 hours, or overnight if preferred.4. After incubation, add 1μl of Quencher reagent for every 10μl of antibody used. Leave to stand for 30 minutes before use.

技术参数

产品类型 Conjugation Kit

© bio-rad伯乐一级代理 |伯乐Aminex |伯乐电泳槽1658001| 伯乐ddPCR bio-rad授权代理商、biorad伯乐qpcr仪是专业的授权总代理区域代理经销平台。
© 如需询价，请加客服QQ：1749072012 、客服微信：jinshanbio，或发送邮件到1749072012@qq.com
© 平台为生命科学研究相关领域提供一站式耗材试剂仪器解决方案和采购服务，数据资源基于CC协议。
© 本文地址：https://gibcohyclone.cn/thread-41273.htm

特别声明：以上内容(如有图片亦包括在内)来源于授权厂家或网络，如有侵权，请联系删除，本平台不提供信息存储服务。

Notice: The content above (including the pictures if any)comes from authorized manufacturers or networks. In case of infringement, please contact to delete it. This platform does not provide information storage services.

产品询价需求提交

Lynx Rapid Plus Cy5 antibody conjugation kit™ LNK212CY5 bio-rad ,Lynx Rapid Plus Cy5 antibody conjugation kit™

相关推荐